Stewart Collection of Victorian Cast Iron Gates & Railings

A range of cast iron gates and railings
Dimensions of Stewart cast iron gates and railings

The drawings below show the options available.      You can mix and match!
It is recommended that an intermediate railing post is used approximately every 3.0 metres.
It is also recommended that a railing stay is fitted approximately every 3.0 metres.

A joiner panel is required to connect to each intermediate railing post on one side only.
No joiner panels are required if connecting to piers.

A root fixing post is required if installing an automated gate system.

A hinge and pivot set is required for base plate fixing posts.
GA006
Stewart Cast Iron Driveway Gate Leaf
12ft pair weighing 450kg 		GA005
Stewart Cast Iron Pedestrian Gate
10ft pair weighing 370kg 		GA007
Stewart Cast Iron Pedestrian Gate
885mm wide weighing 117kg
Stewart GA006 cast iron twelve foot wide driveway gates

Stewart GA005 cast iron ten foot wide driveway gates

Stewart GA007 900mm wide cast iron pedestrian gate

GA008A
Stewart Half Height Railing Panel
weighing 20.5kg 		GA017A
Stewart Half Height Railing Joiner Panel with Feet
weighing 10kg 		GA003
Stewart Half Height Railing Post
weighing 23kg
Stewart GA008A half height Victorian cast iron railing panel

Stewart GA017A half height Victorian cast iron railing joiner panel with feet

Stewart GA003 half height Victorian cast iron railing post

GA009
Stewart Full Height Railing Panel with Root Fixing
weighing 24kg 		GA018
Stewart Full Height Railing Joiner Panel with Root Fixing
weighing 18kg 		GA002
Stewart Full Height Railing Post
weighing 38.5kg
Stewart GA009 cast iron railing panels

Stewart GA018 Victorian railing joiner panel

Stewart GA002 cast railing post


DISCLAIMER: ALL MEASUREMENTS ARE APPROXIMATE AND MAY VARY SLIGHTLY DUE TO THE NATURE OF MANUFACTURE.


top of pagehome pagecontact Fine Iron
 Cast Iron Gates 

website design & promotion - StreetwiseUK .
Stewart Collection of cast iron gates and railings